Overall Score (4.7)
(8 reviews / 7 comments)
8 out of 8 reviewers would buy this item again.
I've used these for the past 7-8 years on most of the common ranges, and they work quite well, no failures or issues! The 0-100"WC make excellent tank level indicators for small storage tanks.
These transducers work well every time. For a lower priced unit I don't think they can be beat.
I have used many of these prosense sensors in the cogen industry , they are much cheaper then omega and when applied properly they last just as long as and I much prefer the M12 connector with a preformed cord to the Mini dinn connector on many other brands
I have used the PTD25 series ceramic pressure transducers in about a dozen applications with varying process media: water, steam, pneumatic, and hydraulic circuits often subject to significant pressure spikes. Even in applications without protection of a gauge snubber when I need the fastest signal response, I've never had a sensor fail. Both the 4-20ma and 0-10VDC transducers seem to work equally well. The only possible improvement I can think of is if there was some way to rotate the M12 connector for the situation that the transducer tightens in the process connection leaving a right angle M12 plug pointing in an undesirable orientation. Otherwise an excellent product I will continue to buy ,use and highly recommend.
A high quality pressure sensor at reasonable price. Happy with the purchase.
Easy to use and set up. Very reliable and consistent response when compared to a fully calibrated NIST traceable unit I use. I used this in a lab view environment. One note the conversion factor is 0.01337v/mmHg. Based on calculations it should be around 0.0151 v/mmHg. So this shows there may be some slight variance but 0.01337 v/mmHg worked perfect for me on two different units. Once I got it dialed in very consistent and accurate from 0-780 mmHg.
I use these sensors for steam and process automation projects. I have never had one go bad.
No comment was provided.