Signal Conditioners with DC Voltage, Current, or Potentiometer Input

Potentiometer Input, Analog Output Signal Conditioner

The potentiometer-to-analog signal conditioner converts a resistive input to an isolated analog output. The input resistive range is set using a pushbutton programming routine.

• 0-100 ohms up to 0-100 kilohms input ranges
• 0-5 V, 0-10 V, 0-20 mA, 4-20 mA output ranges
• DIP switch selectable output ranges
• Pushbutton adjustable to 10% of the full range of the potentiometer
• 24 VAC/VDC operating voltage
• Min max, and power LED status indication
• DIN rail or side mounted

Universal Signal Conditioners

Universal signal conditioners accept mA, VDC, thermocouple, RTD, linear resistance, or potentiometer inputs and provide relay, frequency, and/or analog outputs (depending on the model).

• Selectable current, voltage, RTD, thermocouple, or potentiometer inputs
• Current, voltage, frequency, and/or configurable relay output options
• 21.6-253 VAC / 19.2-300 VDC operating voltage
• LED status indication
• Programming/display module required (sold separately)
• IP20 protection rating
• cULus, FM, and CE marked

High-Density Signal Conditioners

High-density signal conditioners provide conversion of standard DC voltage, current, and bipolar signals, and are housed in a narrow 6mm width housing to optimize panel space.

• Single channel, two channel, and signal splitter models
• Isolation eliminates ground loop problems
• In-rail power bus for select models
• Fixed or DIP switch selectable configuration
• LED operation status on some models
• Excellent accuracy and fast response time
• Suitable for high vibration environments
• UL Listed; FM approved for use in Class 1 Division 2 hazardous locations

WAGO PNP/NPN Converter

Easily convert a signal from PNP to NPN or vice-versa by moving a couple of wires and changing the internal jumper on these terminal-block style signal converters.