Cookies are not enabled on your browser.
Cookies are required for our site. Please enable cookies in your browser preferences to continue.
AutomationDirect will close at 3:00 PM ET on Wednesday, Nov 27th. We will also be closed on Thursday & Friday, Nov 28th & 29th, for Thanksgiving. The shipping cutoff for same-day FedEx shipments on Wednesday, Nov 27th is 3:00PM ET. Freight shipments as well as customer pickups deadline is 1:00PM ET. There will be NO UPS shipping available on Wednesday. Orders placed after the same-day shipping cutoff times will ship on Monday, December 2nd.
(VID-DD-0013) - This video gives basic information on Using the DRUM "Timed/ Event/ Timed-Event Drum" instruction in the Do-more designer software. It presents information that is commonly missed by users. This WILL NOT be a complete tutorial for the instruction but rather a supplement to the help file and customer experience.
** Software Version used in this video: Do-more Designer 2.0
This is a multi-scan instruction, because it takes multiple scans to complete, it cannot be used in either Subroutines or Interrupt Service Routines. It can used in Programs and under special circumstances can it be used in Stages inside of a Program or in Tasks. See the help topic “Instruction Set Chart” for more information. The Drum instruction writes to a Heap item that can be found here. Any outputs that you place in the Drum will be controlled by the Drum when the PLC is in Run. So do not try to control any of these outputs elsewhere in your program The Step Preset is the step in which the Drum will start on when enabled or reset. Each step of the drum you can select a Time, an event or both a Time and event. If you select both Time and event, the time will only start counting down once the Event becomes true. When the Drum has ran through all of it’s steps it will remain in the last output state until the instruction is reset.