Loading...
IronHorse ACG Series AC Drives
The ACG series of sensorless vector AC drives bridge the gap between a micro drive and high-performance VFD. The ACG series AC drives have features normally only found on more expensive drives but at a great price.
Starting at $184.00
IronHorse ACG Series AC Drive Features
These are just some of the features for the ACG series drives. You will be hard-pressed to find a drive for the same price with all of the features it supports.
- Single-phase UL Ratings - 230 or 460 VAC input
- Supports several different control modes including V/Hz, slip compensation, and sensorless vector
- Flexible carrier frequency to 15khz
- Output frequency to 400Hz (120Hz sensorless vector)
- Built-in RJ45 port for fast & easy programming
- Free downloadable software for drive configuration
- Local/Remote control mode selection or digital/comm input with Hand/Off/Auto control
- Momentary power loss restarts
- PCB conformal coating
- 100kA Short Circuit Current Rating
- DC Bus Connection Terminals
- Discrete I/O - 5 inputs and 2 relay outputs
- Analog I/O - configurable 2 inputs and 1 output (voltage)
- 2-motor control
- Built-in dynamic braking
- PID Controller - including sleep and wake
- Password protection
- High speed communication interfaces with MODBUS RTU built-in, with optional EtherNet/IP and Modbus TCP Communication Card
- Fire Mode - Run fire mode during emergencies to have uninterrupted smoke removal and system pressure
- 2-year warranty
- CE, UL, cUL
- Also available in NEMA 4X versions as the ACN and ACNND
Optional Ethernet Capability
A low cost drive doesn't have to sacrifice modern communications. The ACG-ET2 module is easily mounted on the front of the drive, and provides Ethernet communications through Modbus TCP or EtherNet/IP. Dual ports allow point to point or daisy chain wiring configurations. Connect a laptop to the same Ethernet network, and seamlessly connect VFD suite software for easy configuration and monitoring of your ACG drive.
The USB-485M cable allows for a quick and simple connection for programming the ACG series drives. Programming the drives is also supported over Ethernet if an ACG-ET2 module is installed.
Updating...